Camp-chef PZOVEN Bedienungsanleitung PDF herunterladen (Seite 5)

• Do not use an open flame to check for

gas leaks.

• Appliance must be leak checked

outdoors in well-ventilated area, away

from ignition sources such as gas

fired or electrical appliances. During

leak test, keep appliance away from

open flames or sparks.

Use a clean paintbrush and 50/50 soap

and water solution. Use mild soap

and water. Do not use household

cleaning agents. Damage to gas train

components can result. Brush soapy

solution onto all weld seams and entire

valve area.

Setup Using Hose And

Refillable Cylinder

1. Place LP tank on a secure, level, and

stable surface.

2. Make sure burner valves are off.

3. Turn LP tank OFF by turning wheel

clockwise to a full stop.

4. Remove the protective cap from LP

tank valve. Always use cap and strap

supplied with valve. DO NOT USE

A POL TRANSPORT PLUG (plastic

part with external threads)! IT WILL

DEFEAT THE SAFETY FEATURE OF

THE VALVE.

LP Tank Filling

• Use only licensed and experienced

dealers.

• LP dealer must purge tanks before

filling.

• Dealer should NEVER fill LP tank

more than 80% of LP tank volume.

Volume of propane in tanks will vary

by temperature.

• A frosty regulator indicates gas

overfill. Immediately close LP tank

valve and call local LP gas dealer for

assistance.

• Do not release liquid propane (LP)

gas into the atmosphere. This is a

hazardous practice.

• To remove gas from LP tank, contact

an LP dealer or call a local fire

department for assistance. Check

the telephone directory under “Gas

companies” for nearest certified LP

dealers.

LP Tank Exchange

• Many retailers that sell appliances

offer you the option of replacing your

empty LP tanks through an exchange

service. Use only those reputable

exchange companies that inspect,

precision fill, test and certify their

cylinders. Exchange your tank only for

an OPD safety feature-equipped tank

as described in the “LP Tank” section

of this manual.

• Always keep new and exchanged

LP tanks in upright position during

use, transit or storage.

• Leak test new and exchanged

LP tanks BEFORE connecting

to appliance.

LP Tank Leak Test

For your Safety

• Leak test must be repeated each time

LP tank is exchanged or refilled.

• Do not smoke during leak test.

5. Attach hose to regulator & regulator

to stove (as shown).

6. Attach hose to cylinder.

7. Slowly open cylinder valve.

8. Perform leak check on regulator to

oven, hose to regulator and hose to

cylinder connections with soapy water.

Arrows indicate areas to be checked

for leaks. Bubbles indicate a leak.

Check that the connection is not cross-

threaded and that it is tight. Perform

another leak check. If there is still a

leak, remove the cylinder and contact

the manufacturer for service and repair.

9. Turn off fuel at the cylinder and

disconnect both ends of the hose when

not in use.

Dismantling Hose And

Refillable Cylinder

1. Before dismantling high pressure

hose, be sure gas pressure in hose is

eliminated.

2. Ignite oven and turn off gas valve on

cylinder.

3. Allow flame to self-extinguish.

4. When flame is out, close valves on

the appliance.

5. Remove hose.

Lighting Oven Instructions:

Do not lean over the Oven while

lighting.

1. Push the gas valve knob in and turn

slowly to the high position. The

Oven Burner will ignite. (If lighting

with a match, light match and place

it over the burner. Slowly turn on

the valve. Do not stand with head or

arms over the burner.)

2. Keep handle depressed for 10

seconds.

3. If the burner does not stay lit repeat

the process.

4. Adjust the controls to the desired

position.

5. If ignition does not occur in 5

seconds, turn the burner control(s)

off, wait 5 minutes, and repeat the

lighting procedure. If built-in ignitor

will not light follow the preceding

steps and hold a lit long igniter

to match next to the burner when

opening the control valve.

If the flame is accidentally

extinguished, turn the appliance

valves OFF and WAIT 5 minutes before

attempting to ignite.

Burner Flame Check

• Light burner; rotate knob from HIGH

to LOW. You should see a smaller

flame in LOW position than seen on

HIGH. Always check flame prior to

each use. A good flame should be

blue with minimal yellow tip. Some

yellow tips on flames are acceptable

as long as no carbon or soot deposits

appear.

WARNING

If “growing” bubbles appear,

do not use or move the LP tank.

Contact an LP gas supplier or your

fire department.

1 2 3 4 5 6

Kommentare zu diesen Handbüchern

Keine Kommentare

Camp-chef PZOVEN Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Camp-chef PZOVEN